OneUp E-Chainguide – STEPS

Introduction

Eliminate dropped chainsforeverand add a touch of colour to your e-bike with the new OneUp Components STEPSChainGuide.

The OneUp STEPSChainGuide is lightweight and incrediblyeasy to install and use. The top guide has a tool-free flip featurethat allows easy accessto your chain for cleaning andmaintenance.

Top guide pieces are available in 6 bright colours to perfectly match your OneUp Composite Pedals, Grips and EDC Lite.

Compatible with 32T to 38T chainrings.
Weighs just 45g.

FEATURES
Shimano STEPS E7000, E8000 and EP8 compatible
Includes black top guide piece. 6 other colours sold separately
Tool-less upper guide flip
Install without removing your cranks
Mounts directly to motor
Single tool install and adjustment (4mm hex)
Black Stainless-Steel hardware
Patented US10,053,188 Other Patents Pending

SPECS
Weight:45g
Capacity:32-38T
Chainline:5mm adjustment
Mount:Shimano STEPS/EP8
Colour:Black top guide piece included. Blue, Green, Orange, Purple, Red, Turquoisesold separately.
Material: Back Plate – 7075 aluminium, Top Guide – glass reinforced thermoplastic

COMPATIBILITYNot compatible with 2021 Orbea Rise Alloy or Carbon frames

GUIDE SETUP INSTRUCTIONS

1. Remove top guideby removing the front top guide nut with a 4mm hex (never adjust the rear T25 bolt).2. Set slider in the highest position
3. Hold backplate directly againstShimanomotortabs.Check for clearance between the back side of the guide and the bike frame.4. Install mounting bolts loosely and rotate backplate untilslider adjustment bolt is directly above the crank axle.5. Torque bolts to 5Nm
6. With crankset and chain installed, use spacer shim block to measure clearance between back plate and chain
7. Determine the corresponding number of chainline shims required
8. Assemble top guide with spacers and tighten bolt to 3Nm9. Insert a 4mm hex through the hole in the inner top guide, loosen height adjustment bolt and lower the tool onto the chain. Torque to 3Nm to setheight.